CANAKIT USB PIC PROGRAMMER MAC

PK2Error0027: Failed verify (Address = 0x0 - Expected Value 0x118a - Value Read 0x0) Programming Program Memory (0x100 - 0x5fb) PKWarn0003: Unexpected device ID: Please verify that a PIC16F88 is correctly installed in the application. Programming Program Memory (0xda4 - 0xec7) Programming Program Memory (0xa60 - 0xa9f) Programming Program Memory (0x800 - 0x92b) Programming Program Memory (0x100 - 0x5ff) Target power not detected - Powering from PICkit 2 5.00 PK2Error0023: Target Vdd measured at 0.00V which is outside the programmable range of this device ( 2.50V - 5.50V) PICkit 2 Settings: Using target power always. Note the first programming at 22:14:30 worked, but the second did not.įound PICkit 2 - Operating System Version 2.32.0 Not sure if anything prior is a cause of the issue or just coincidence.

CANAKIT USB PIC PROGRAMMER MAC

Returned to MPLABX in Mac 10.6 and got only 1 successful rewrite before getting the same error again. Tried using PicKit2 App in Windows to restore operation with the 'program first time using VDD' which led to a successful write operation there. haven't been able to complete programming successfully in MPLAB thereafter. then accidentally had the MCLR line jumped to the RA4 line on the PDP2 board during a programing operation which lead to a programming target failure. I've been working with MPLABX for several weeks setup with a 16F88 on a breadboard and jumped to a PicKit2 + PicDemPlus2 for programming.

Canakit usb pic programmer